CCNA 3 Final Exam Answers version v – % Full, CCNA v5. v The new switch has a VTP revision number of 4. CCNA v Routing and Switching Exam Answers , Free CCNA Study Guide, Tutorials, Labs, Practice Exams. CCNA Security, , v CCNA 2 v Capitulo 4 Examen Online en Español Cisco CCNA 1 Capitulo 4 Examen Pregunta 13 Cisco CCNA2 v Capítulo 3 Examen Pregunta

Author: Zujar Keshura
Country: Czech Republic
Language: English (Spanish)
Genre: Technology
Published (Last): 11 May 2004
Pages: 434
PDF File Size: 8.51 Mb
ePub File Size: 14.82 Mb
ISBN: 906-9-96794-229-5
Downloads: 89099
Price: Free* [*Free Regsitration Required]
Uploader: Jull

What benefits does this configuration provide?

DMC Cisco Networking Academy

One of the router subinterfaces is possibly down. Reply Marcelo Soares says: The answer is WPA2. STP is automatically enabled. The Cisco CCNA network associate certification validates the ability to install, configure, operate, and troubleshoot medium-size routed and switched networks.

Attach the web server to a router and configure inter-VLAN routing. August 9, at 7: The configuration is appropriate for a router-on-a-stick network design. What two methods can be used to remove MAC address table entries from a switch?

CCNA 3 Final Exam V Answers

Documents Flashcards Grammar checker. November 30, at 8: Chapter 1 – Study Guide. The switch port is configured for auto duplex and the PC is configured for full duplex. May 1, at The port will transition into blocking state and immediately transition through the listening and learning states. Cccna 13, at 2: If HostA sends a broadcast frame to SW1, which devices will receive the frame? A successful trunk will be established if the remote switch is non-Cisco but ccna port is configured for trunking.


However, hosts B and D cannot ping each other. Allow all VLANs on the trunk link. October 18, at 3: March 24, at 9: Module 6 – IT, Sligo. October 12, at 6: All trunk links are operational and all VLANs are allowed on all descargag links.

October 13, at 8: The switch port is able to trunk if the remote switch port is set to auto. The clear switching-tables command will remove statically configured entries. A backup configuration from a TFTP server cannot be copied directly into vescargar startup-config.

The VTP configuration revision is different on both switches. December 17, at 2: V44.0 are two benefits of the IEEE Subsequent attempts to telnet to the switch are not successful.

December 8, at 9: Switches S2 and S3 are properly connected using an ethernet cable. It is receiving BPDUs, but not sending data frames.

CCNA 3 Final Exam V4.0 Answers

January 11, at 8: What is one disadvantage that July 13, at 2: October 13, at Configure the switch with the same VTP domain name as other switches in the network. December 12, at 1: Refer to the exhibit.


July 4, at 5: What is the cause of this problem? Traffic inbound on this router is processed by different subinterfaces, depending on the VLAN from which the traffic originated. Whenever an inter-switch link fails, the network takes nearly a minute to completely converge.

What is the most likely ccnq of this problem? The ip domain-name command must also be entered in line configuration mode for the vty lines. The network administrator wants to configure a switch to pass VLAN update information to other switches in the domain but not update its own local VLAN database.